Home | Ezine | Forums | Links | Contact
NitroExpress.com: Can anyone offer an estimated market value?

View recent messages : 24 hours | 48 hours | 7 days | 14 days | 30 days | 60 days | More Smilies


*** Enjoy NitroExpress.com? Participate and join in. ***

Double Rifles, Single Shots & Combinations >> Double Rifles

SaxonPig
.224 member


Reged: 04/05/04
Posts: 5
Re: Can anyone offer an estimated market value?
      06/05/04 04:35 AM

I freely admit that I am not an expert on English double rifles. That's why I asked for help. I can recognize that my rifle is not a top grade product. It has no embellishment or ornamentation. It does strike me a well-made gun even though it is not a fancy one. But then, this is the only DBR I have ever owned, so perhaps I am easily fooled? I can assure you that the fit and finish on this rifle is nice. No, it is certainly not up to the standard of a top quality H&H or Purdy, but I suspect the monetary values on the guns would reflect the difference between them. This rifle is now 94 years old, and has not been pampered, yet the bluing still looks nice save for the obvious wear in those areas where the gun was handled.

As for function, the action opens and closes smoothly and locks up tightly when closed. The trigger pull (pulls?) is decent and as I noted, the barrels appear to be regulated to within one inch at 100 yards despite your assertion that C&H didn't pay much attention to this detail.

You do not hold the maker of my gun in high regard. That is your right and in a discussion of the merits of one manufacturer versus another you would be quite correct in expressing your views and offering whatever evidence you have to support your position. However, taking my thread as an opportunity to air your contempt for C&H sort of suggests that you consider me to be foolish for owning one, no? Well, I assume your intent was an honest discussion and not personal slight, so it is water under the bridge as far as I am concerned.

On the matter of the caliber, again, I must confess to some ignorance on the English cartridges. But my rifle is, indeed, chambered for the .375 bore cartridge with a rimmed case of 2.5 inches in length. The case is straight-walled (well, it has a slight taper but no shoulder) and the rilfe is marked ".375 Nitro Express." Also stamped on the underside of the barrels is the load information, indicating a 270 grain bullet was used over a charge of 40 grains of Cordite.

I would still be interested in any opinions as to fair market value. I will see if I have a photograph of the rifle to post as some have stated it would help. Thanks.

OK, I found a photo. Not the best image, but I hope it helps. By the way, it does not have automatic ejectors.



Edited by SaxonPig (06/05/04 04:58 AM)

Post Extras Print Post   Remind Me!     Notify Moderator


Entire topic
Subject Posted by Posted on
* Can anyone offer an estimated market value? SaxonPig 04/05/04 09:17 AM
. * * Re: Can anyone offer an estimated market value? SaxonPig   04/05/04 10:56 PM
. * * Re: Can anyone offer an estimated market value? 475Guy   04/05/04 11:02 PM
. * * Re: Can anyone offer an estimated market value? NitroXAdministrator   04/05/04 08:07 PM
. * * Re: Can anyone offer an estimated market value? holland465   04/05/04 05:00 PM
. * * Re: Can anyone offer an estimated market value? 470Rigby   04/05/04 11:09 PM
. * * Re: Can anyone offer an estimated market value? holland465   06/05/04 03:27 PM
. * * Re: Can anyone offer an estimated market value? 470Rigby   06/05/04 04:44 PM
. * * Re: Can anyone offer an estimated market value? holland465   06/05/04 05:04 PM
. * * Re: Can anyone offer an estimated market value? 470Rigby   07/05/04 10:59 AM
. * * Re: Can anyone offer an estimated market value? atkinson6   14/05/04 04:45 AM
. * * Re: Can anyone offer an estimated market value? mickey   05/05/04 12:01 AM
. * * Re: Can anyone offer an estimated market value? 470Rigby   05/05/04 01:10 PM
. * * Re: Can anyone offer an estimated market value? SaxonPig   06/05/04 04:35 AM
. * * Re: Can anyone offer an estimated market value? NitroXAdministrator   07/05/04 01:42 AM
. * * Re: Can anyone offer an estimated market value? 475Guy   06/05/04 01:22 PM
. * * Re: Can anyone offer an estimated market value? mickey   06/05/04 06:34 AM
. * * Re: Can anyone offer an estimated market value? SaxonPig   05/05/04 04:41 AM
. * * Re: Can anyone offer an estimated market value? 470Rigby   05/05/04 10:00 AM
. * * Re: Can anyone offer an estimated market value? RLI   05/05/04 07:49 AM
. * * Re: Can anyone offer an estimated market value? Marrakai   04/05/04 10:11 PM
. * * Re: Can anyone offer an estimated market value? mickey   04/05/04 11:51 AM

Extra information
0 registered and 90 anonymous users are browsing this forum.

Moderator:  CptCurl 



Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 4974

Rate this thread

Jump to

Contact Us NitroExpress.com

Powered by UBB.threads™ 6.5.5


Home | Ezine | Forums | Links | Contact


Copyright 2003 to 2011 - all rights reserved