Forums.NitroExpress.com

Wanted to share a few photos of a recent experience I had at the local NRA gunsmithing school. I signed up for the one week summer course on "Blueprinting Actions". The students and faculty were great. Couldn't have met a nicer group of people and a great way to spend vacation.

The action I worked on was a remington 700. All machining was indicated in coaxialy and cut single point. Action will be barreled with a match reamer in .308. Here are some pics;

Creating a Mandrel for a tight clearance fit to the raceways. Dial indicators were then set up off the mandrel to coaxially indicate in the action.

The receiver in a cats head / spyder fixture after being indicated in. Facing the receiver face at this point.

Single point cutting of internal threads. A lot of pucker factor on this one. Have to accomplish this operation referencing only dial readouts.

Machining the bolt true after indicating it in (another fixture).

LRWest

Edited by CptCurl (31/07/10 02:30 AM)

Post Extras