Quote:

---

Hell, maybe I should just rebore the sucker to 450/400 3" if wall thickness is nominal..

---

I had the same thought and briefly looked at the .375 and .450/.400 drawings. The .400 is only 2.1" to the shoulder, with a .440" neck. The .375 is 2.4" to a .450" shoulder, so I'm not sure that the .450/.400 3" reamer would entirely clean up the .375 chamber. I haven't looked at it very hard though.

Maybe .500/.416?

Are the .375 bores shot out?

--------------------
"Serious rifles have two barrels, everything else just burns gunpowder."

Post Extras