Quote:

---

From memory, I think it has been recommended to reduce the FMJ load by one grain. Due to the thick jacket.

---

Quote:

---

Those groups look very good. I wonder if slightly less velocities will raise or lower the FMJ bullet impact. Usable as is, I'd sight it point of aim at 100 yards for the FMJ. An inch plus for the SP. While the SP would be used most, the FMJ is the serious bullet for serious times. Up to 100 metres. Just aim dead on.

---

Quote:

---

BTW what is the exact inch calibre diameter? (Answered at the Woodleigh website 11.2 Schuler .440".) And thanks to GV and yourself for the information on the cartridge and ballistics. Amazing and useful that GV also has an rifle chambered in the same cartridge. Very rare. And earlier information by the other expert contributors

---

Quote:

---

Well done. I'd never heard of the 11.2x72mm before. I like the idea of unique unusual but very usable cartridge chamberings. Except if you ever need to replace lost ammunition. Then one would want the most common cartridges available.

Well done again. Not a .404 but an even rarer and useful 11.2x72 Schuler.

---

You are correct. Other calibers are much more practical with better ammo availability. The 11.2x72 Schuler is limited to hand-loading custom ammo. And whats really disappointing is Woodleigh discontinuing bullets in .440" diameter because of low demand. Bullets are still available from HAWK and CUTTING EDGE. However the CUTTING EDGE bullets are lathe turned solids and are very long and cannot achieve the velocities obtainable with HAWK and Woodleigh bullets. If other shooters here in the U.S. need .440" bullets for their rifles, I can bump-up .422" bullets to .440" with my Corbin swage dies. (Softs only - NOT solids - see the Peterlongo link above)

--------------------
"You never pay too much for something, you only buy it too early."

Post Extras