Forums.NitroExpress.com

Home | Ezine | Forums | Links | Contact NitroExpress.com: sizing dies

*** Enjoy NitroExpress.com? Participate and join in. ***

You are not logged in. [Login]

Main Index · Search · Active Topics
New user · Who's Online · FAQ · Calendar

Double Rifles, Single Shots & Combinations >> Paradox and Bore Guns

Jim_C
.300 member

Reged: 09/08/14
Posts: 177
Loc: USA

Re: sizing dies
09/06/22 03:14 PM

Lee tops out at .510" or so, I suspect as much for reasons of commercial demand as anything else. I've lapped them out to .519", and made similar dies (7/8x14 threads) in .579". I think .710" would have to be made on larger threaad size.

If you've got a press large enough to load cartridges taking those bullets, just make Lee-style dies to fit your thread size. In an RCBS Rockchucker, you could start with a piece of threaded rod (or a bolt) in 1-1/4x12; that should be large enough to bore and ream to size bullets to .840".

Post Extras

Entire topic
Subject	Posted by	Posted on
sizing dies	franzsodia	03/06/22 08:06 AM
Re: sizing dies	3DogMike	03/06/22 09:06 AM
Re: sizing dies	DarylS	03/06/22 09:50 AM
Re: sizing dies	Jim_C	09/06/22 03:14 PM

Extra information

0 registered and 6 anonymous users are browsing this forum.

Moderator: tinker

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 1788

Jump to

NitroExpress.com

Home | Ezine | Forums | Links | Contact