Home | Ezine | Forums | Links | Contact
NitroExpress.com: An Ode To The 250-300 Savaged Improved...

View recent messages : 24 hours | 48 hours | 7 days | 14 days | 30 days | 60 days | More Smilies


*** Enjoy NitroExpress.com? Participate and join in. ***

Shooting & Reloading - Mausers, Big Bores and others >> Rifles

DarylS
.700 member


Reged: 10/08/05
Posts: 27006
Loc: Beautiful British Columbia, Ca...
Re: An Ode To The 250-300 Savaged Improved...
      13/02/22 07:06 AM

If your rifle is a CZ, 260Rem, it will do better than 3,015 if you use a Lee Factory crimp die, RP brass and LG powder. The 40gr. Vmax, 40gr. Ballistic Tip and 40gr. Barnes Varminator
Both of my CZ's exceeded 3,300fps with those bullets & my brass went 14 rounds without a single loss. No expanded pockets, no split necks.
The RP brass is necessary to get these ballistics. It is the thinnest of all the brass, yet showed more than ample strength. WW brass can load up to 13.5gr. in those CZ 527's and achieve just over 3,200fps with them.
My best gopher shot was 454yards with the Ballistic Tip Nosler, vel. 3,357fps. I only partial FL sized them to about 1/2 neck length, with long oal as possible, only 1/10" of bullet in the case and crimped in the die. This, of course, further increased the capacity. My CZ routinely made groups well under 3/8", even under .200" at 100 meters, making only slightly oblong holes for 3 shots. 5 shot groups went under 3/8".
An amazing ctg. in these rifles. The Ruger #1's as well as M77 .22Hornet and TC Contenders also handle these loads perfectly. As the pressure is said to be in the 50,000PSI range, these loads are not recommended for older or weaker actions- at all.
That I was able to use pistol primers with never piercing a primer, shows the pressures not over 50,000psi, and likely in the 45,000psi range. 45,000psi is said to be max. for pistol primers.
My first CZ went over 7,000rounds of these loads with the original 500cases I purchased, before I turned all the brass into .17AH's and used a re-chambered .17 Rem CZ take-off barrel. The brass was fireformed and loaded twice more for a total of 17 times before it needed to be annealed.
I will note at this time, that the CZ Hornets I have had (2) both had quite snug chambers, as well as the .22 Hornet Rugers I tested and the TC Contender. All worked well with the WW brass at 13.5gr. and the RP brass with 14.0gr. and 14.4gr. LG loads.

edited- sorry 7,000rounds not 14,000.

--------------------
Daryl


"a gun without hammers is like a Spaniel without ears" King George V

Edited by Daryl_S (13/02/22 11:45 AM)

Post Extras Print Post   Remind Me!     Notify Moderator


Entire topic
Subject Posted by Posted on
* An Ode To The 250-300 Savaged Improved... Ripp 11/02/22 01:36 AM
. * * Re: An Ode To The 250-300 Savaged Improved... DarylS   11/02/22 04:37 AM
. * * Re: An Ode To The 250-300 Savaged Improved... 85lc   12/02/22 08:30 AM
. * * Re: An Ode To The 250-300 Savaged Improved... DarylS   12/02/22 11:49 AM
. * * Re: An Ode To The 250-300 Savaged Improved... NitroXAdministrator   12/02/22 08:11 PM
. * * Re: An Ode To The 250-300 Savaged Improved... 260rem   12/02/22 10:47 PM
. * * Re: An Ode To The 250-300 Savaged Improved... 93x64mm   13/02/22 08:06 AM
. * * Re: An Ode To The 250-300 Savaged Improved... DarylS   13/02/22 07:06 AM
. * * Re: An Ode To The 250-300 Savaged Improved... 260rem   13/02/22 11:37 AM
. * * Re: An Ode To The 250-300 Savaged Improved... DarylS   13/02/22 11:46 AM
. * * Re: An Ode To The 250-300 Savaged Improved... 260rem   13/02/22 05:16 PM

Extra information
0 registered and 219 anonymous users are browsing this forum.

Moderator:   



Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 1406

Rate this thread

Jump to

Contact Us NitroExpress.com

Powered by UBB.threads™ 6.5.5


Home | Ezine | Forums | Links | Contact


Copyright 2003 to 2011 - all rights reserved