Forums.NitroExpress.com

Home | Ezine | Forums | Links | Contact NitroExpress.com: Ball size for a smooth bore if bore sizes slightly differ?

*** Enjoy NitroExpress.com? Participate and join in. ***

You are not logged in. [Login]

Main Index · Search · Active Topics
New user · Who's Online · FAQ · Calendar

Double Rifles, Single Shots & Combinations >> Paradox and Bore Guns

DarylS
.700 member

Reged: 10/08/05
Posts: 26994
Loc: Beautiful British Columbia, Ca...

Re: Ball size for a smooth bore if bore sizes slightly differ?
31/12/20 10:08 AM

I used a slightly rounded/angled crimp on my patched ball loads, in annealed brass cases.
I also wondered if the patches would stay with the balls as the ball left the base mouth.
This appeared to be the case, as evidenced by the after shot patch retrieval, just as if they'd been shot from a muzzle loaded gun.
There is some speculation that the crimps open up as the case expands with initial ignition of the powder, even before the ball or bullet
starts to move. Of that I have my doubts, but, they seemed to work just the same. The patches I used, came right to the top of the
case mouth, well around the periphery of the loaded ball. This itself, might have been important.

--------------------
Daryl

"a gun without hammers is like a Spaniel without ears" King George V

Post Extras

Entire topic
Subject	Posted by	Posted on
Ball size for a smooth bore if bore sizes slightly differ?	Kynoch	29/12/20 04:07 AM
Re: Ball size for a smooth bore if bore sizes slightly differ?	tinker	29/12/20 04:52 AM
Re: Ball size for a smooth bore if bore sizes slightly differ?	lancaster	29/12/20 04:59 PM
Re: Ball size for a smooth bore if bore sizes slightly differ?	DarylS	30/12/20 10:04 AM
Re: Ball size for a smooth bore if bore sizes slightly differ?	Kynoch	31/12/20 06:28 AM
Re: Ball size for a smooth bore if bore sizes slightly differ?	DarylS	31/12/20 10:08 AM
Re: Ball size for a smooth bore if bore sizes slightly differ?	lancaster	31/12/20 05:13 PM
Re: Ball size for a smooth bore if bore sizes slightly differ?	DarylS	01/01/21 05:01 AM
Re: Ball size for a smooth bore if bore sizes slightly differ?	Kynoch	01/01/21 08:35 AM

Extra information

0 registered and 78 anonymous users are browsing this forum.

Moderator: tinker

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 2901

Jump to

NitroExpress.com

Home | Ezine | Forums | Links | Contact