Home | Ezine | Forums | Links | Contact
NitroExpress.com: Ball size for a smooth bore if bore sizes slightly differ?

View recent messages : 24 hours | 48 hours | 7 days | 14 days | 30 days | 60 days | More Smilies


*** Enjoy NitroExpress.com? Participate and join in. ***

Double Rifles, Single Shots & Combinations >> Paradox and Bore Guns

DarylS
.700 member


Reged: 10/08/05
Posts: 26994
Loc: Beautiful British Columbia, Ca...
Re: Ball size for a smooth bore if bore sizes slightly differ?
      30/12/20 10:04 AM

I had the same thoughts as lancaster when first seeing this post, but held my tongue to see what someone with double rifles would say.
I have successfully used patched, undersized balls in a couple SxS smoothbores - a 12 (.729") and a 13 bore (.705").
I also had very good luck in the 12 bore, using cut-off plastic shot-cup bases form trap wads, cup-up under the the ball and cup-down on the powder,
with spacer wads between them when needed for smokeless loads and without the spacers when using BP loads.
Both worked well, however the patched balls, of course, shot much more cleanly due to the Neetsfoot Oil on the patches, which softened the powder
fouling of successive shots.

Post Extras Print Post   Remind Me!     Notify Moderator


Entire topic
Subject Posted by Posted on
* Ball size for a smooth bore if bore sizes slightly differ? Kynoch 29/12/20 04:07 AM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? tinkerModerator   29/12/20 04:52 AM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? lancaster   29/12/20 04:59 PM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? DarylS   30/12/20 10:04 AM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? Kynoch   31/12/20 06:28 AM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? DarylS   31/12/20 10:08 AM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? lancaster   31/12/20 05:13 PM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? DarylS   01/01/21 05:01 AM
. * * Re: Ball size for a smooth bore if bore sizes slightly differ? Kynoch   01/01/21 08:35 AM

Extra information
0 registered and 108 anonymous users are browsing this forum.

Moderator:  tinker 



Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 2901

Rate this thread

Jump to

Contact Us NitroExpress.com

Powered by UBB.threads™ 6.5.5


Home | Ezine | Forums | Links | Contact


Copyright 2003 to 2011 - all rights reserved