Home | Ezine | Forums | Links | Contact
NitroExpress.com: loaded 4 test rounds for my 16 ga pinfire.

View recent messages : 24 hours | 48 hours | 7 days | 14 days | 30 days | 60 days | More Smilies


*** Enjoy NitroExpress.com? Participate and join in. ***

Shooting & Reloading - Mausers, Big Bores and others >> Shotguns

casper50
.400 member


Reged: 18/10/07
Posts: 1340
Loc: Alaska
Re: loaded 4 test rounds for my 16 ga pinfire.
      07/08/19 05:31 AM

My friend with the lathe convinced me that turning 25 inconsistent magtech brass would be a lot more work than making the chamber rims fit the cartridge. So no lathe work on the brass. I tried to use the cases as they were, leaving the primer pocket on the inside but I could not get consistent ignition because of the hard angle. So I drilled the primer pocket from the inside of the case until it was flush with the base. I then epoxied a thin 5/8" brass disc inside the case all the way at the bottom. Next step is to take a 1/4" over powder card and punch 1 hole in the middle and then bite out just a bit of one side to make it slightly oblong 7/32". Primer fits inside this hole in the wad. Push the wad all the way to the base and then drill the hole for the brass firing rod through the case and the paper wad. Position a cap into the paper wad hole and push in the firing rod. Then just load as normal. Since I reduced the angle of the firing rod I've had no misfires or failure to fire. I tried to do the same with 100% plastic hulls but they are too small of a diameter inside for my wads and overpowder cards. I have been sent a small brass insert that inserts from the rear with a cap already inside. I will try this method as well as soon as I get the proper size drill bit to drill the hole into the base.

Post Extras Print Post   Remind Me!     Notify Moderator


Entire topic
Subject Posted by Posted on
* loaded 4 test rounds for my 16 ga pinfire. casper50 07/08/19 04:57 AM
. * * Re: loaded 4 test rounds for my 16 ga pinfire. lancaster   07/08/19 05:21 AM
. * * Re: loaded 4 test rounds for my 16 ga pinfire. casper50   07/08/19 05:31 AM
. * * Re: loaded 4 test rounds for my 16 ga pinfire. 93x64mm   07/08/19 05:58 AM
. * * Re: loaded 4 test rounds for my 16 ga pinfire. casper50   07/08/19 06:11 AM
. * * Re: loaded 4 test rounds for my 16 ga pinfire. tinker   07/08/19 10:57 AM
. * * Re: loaded 4 test rounds for my 16 ga pinfire. DarylS   09/08/19 06:35 AM
. * * Re: loaded 4 test rounds for my 16 ga pinfire. casper50   09/08/19 04:38 PM

Extra information
1 registered and 7 anonymous users are browsing this forum.

Moderator:  NitroX 



Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 1727

Rate this thread

Jump to

Contact Us NitroExpress.com

Powered by UBB.threads™ 6.5.5


Home | Ezine | Forums | Links | Contact


Copyright 2003 to 2011 - all rights reserved