Home | Ezine | Forums | Links | Contact
NitroExpress.com: a 1916 Erfurt Kar 98a 6.5x57 project

View recent messages : 24 hours | 48 hours | 7 days | 14 days | 30 days | 60 days | More Smilies


*** Enjoy NitroExpress.com? Participate and join in. ***

Shooting & Reloading - Mausers, Big Bores and others >> Mauser Discussion Forum

VonGruff
.400 member


Reged: 08/02/09
Posts: 1119
Loc: South Otago, New Zealand.
Re: a 1916 Erfurt Kar 98a 6.5x57 project
      23/06/16 09:03 AM

The blind mag well has been done and turned out as well as I could have hoped for.
This is the slow wedge so that when I am routing it down I know that the well will be paralell to the bottom of the stock.


You can see the block that locates into the recoil lug area


There needs to be a means of holding the guide plate to the slow wedge so a length of 2x1 1/2 (cramping blocks) along each side has a notch cut in it to take the ends of the locating block. The top plate was screwed to these cramping blocks and with the notches and screw locating points I can be sure it will all go back to the same configuration on any stock I care to do the same thing to.



The router guide area cut into the top plate was cut undersize at first and with the stock in the vise held by the cramping blocks I could take the top plate off and it would go back into the same place again so I could gradually open up the guide area to leave the correct size well.




--------------------
Von Gruff.

Exodus 20:1-17

Acts 4:10-12

Edited by VonGruff (23/06/16 09:04 AM)

Post Extras Print Post   Remind Me!     Notify Moderator


Entire topic
Subject Posted by Posted on
* a 1916 Erfurt Kar 98a 6.5x57 project VonGruff 22/06/16 02:36 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:38 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:40 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:41 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:42 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:44 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:44 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:45 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   22/06/16 02:48 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project xausa   23/06/16 01:03 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   23/06/16 05:14 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project xausa   23/06/16 09:21 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   23/06/16 12:44 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project dok   23/06/16 08:21 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:18 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:19 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:19 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:20 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:22 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:22 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:24 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:30 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:31 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   25/06/16 02:32 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project HunterGunner   25/06/16 10:04 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project Igorrock   26/06/16 02:26 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   26/06/16 07:42 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project Homer   26/06/16 06:56 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project Igorrock   27/06/16 03:30 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   27/06/16 07:50 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   27/06/16 07:51 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   27/06/16 07:53 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   27/06/16 07:54 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project DarylS   27/06/16 09:53 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   28/06/16 10:41 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   28/06/16 10:41 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   28/06/16 10:42 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   28/06/16 10:43 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   28/06/16 10:48 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project redoak   30/06/16 12:40 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   30/06/16 05:07 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project 93x64mm   30/06/16 05:55 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project Waidmannsheil   30/06/16 06:17 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   30/06/16 10:33 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project DarylS   30/06/16 07:09 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project redoak   01/07/16 03:49 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project mehulkamdar   03/07/16 12:20 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project TexasJohn   26/03/17 10:57 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   27/03/17 03:45 PM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project DarylS   30/06/16 01:01 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project metal   23/06/16 08:21 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   23/06/16 08:55 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   23/06/16 09:01 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   23/06/16 09:03 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   23/06/16 09:07 AM
. * * Re: a 1916 Erfurt Kar 98a 6.5x57 project VonGruff   23/06/16 09:10 AM

Extra information
1 registered and 544 anonymous users are browsing this forum.

Moderator:  NitroX 



Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 14033

Rate this thread

Jump to

Contact Us NitroExpress.com

Powered by UBB.threads™ 6.5.5


Home | Ezine | Forums | Links | Contact


Copyright 2003 to 2011 - all rights reserved