Forums.NitroExpress.com

I used a piece of thin board that is 8 1/2 in deep for the framed pattern so I could get all my measurements noted down.

I started by marking a line the width of my long steel rule (1 1/8) parallel to the top so that when I cut out the interior there is enough strength left outside it to hold it all together. This line is the stock top line and all measurements noted are down from this line. Point A is marked in along this top line and to find point A --- I made my stock to have a 13 3/8 L O P so point A is 14 1/2 in from the butt end of the board. Adjust as necessary for your own desired L O P. I will deal with the forestock first.

From point A, square a line down to the bottom of the board as this is the face of the trigger and where all the measurements go from. From point A mark down the line 2 3/16 as this is the depth of the stock at this point. Measure toward the forend tip 15 1/2 inches and square a line down with a point marked in an 1 1/4 down from the top line. You can now draw a line from this point back through the first point measured down from point A to give you the forestock length and shape.

For the butt end I start with the grip curve so to get there I measure back toward the butt from point A 3 7/8 then square down from there. Measure down that line 4 1/4 and mark the spot. ( call it B) Next comes the grip curve and this calls for a bit of try and adjust. Set you calipers for 4 1/8 as this is the radius for the curve and it requires the curve to go through the point B and back into the line we drew back from the forend tip to intersect where the center of of the trigger curve will be directly down from point A. Then you can use your square and mark in the grip cap line back toward the heel. My intersection point is 14 7/8 back along the top line from point A. Mark 1 3/4 for the grip cap length.
Next comes the comb nose and I mark 4 1/2 back from point A and go down 3/4. This is where the comb nose starts to curve down toward the top of the wrist. Mark back from point A along the top line 13 5/8 and down 1 3/4 to the heel and now you can draw in the comb line. For myself I marked down with a 4 degree negative pitch and drew in the curve for the checkered steel butt plate. If you need a longer L O P I would stoll draw in the drop a heel at the 13 5/8 mark and continue the comb line till you reached your desired L O P.
I am going to grind back the steel plate to give me a length of 4 7/8 so from that point I can draw in the toe line of the butt from the tip of the butt plate to the 1 3/4 mark on the grip cap line.
It will be noted that this line (continued) is above the grip curve by 3/16 - 1/4 but this all helps to lighten the appearance of the stock.

--------------------
Von Gruff.

Exodus 20:1-17

Acts 4:10-12

Post Extras