Forums.NitroExpress.com

Home | Ezine | Forums | Links | Contact NitroExpress.com: Miroku SXS Conversion

View recent messages : 24 hours | 48 hours | 7 days | 14 days | 30 days | 60 days | More Smilies

*** Enjoy NitroExpress.com? Participate and join in. ***

You are not logged in. [Login]

Main Index · Search · Active Topics
New user · Who's Online · FAQ · Calendar

Double Rifles, Single Shots & Combinations >> Building Double Rifles & Gunsmithing

Birdhunter50
.375 member

Reged: 03/06/07
Posts: 815
Loc: Iowa,U.S.A.

Re: Miroku SXS Conversion
02/04/16 11:39 AM

I would not try to tig weld over a brazed joint if I were you. First of all there is no need to do so, and second, you will most likely mess up the tig weld because of brazing contamination trying to get into it and you may also mess up the brazed joint as well. If you want to mill off the short rib section over the monoblock and overlay the rear of the new rib over it, that is O.K., as long as you use heavy duty solder such as Brownells Hi Force 44 to stick it down. Really there is never a good reason to do any welding on the monoblock. Those halves that you spoke of are brazed together in an oven and are as strong as most welded joints because of the amount of surface area involved. Bob

Post Extras

Print Post

Remind Me!

Notify Moderator

Entire topic
Subject	Posted by	Posted on
Miroku SXS Conversion	hlg	25/03/16 01:17 PM
Re: Miroku SXS Conversion	Aaron_Little	29/03/16 01:52 PM
Re: Miroku SXS Conversion	hlg	30/03/16 12:36 PM
Re: Miroku SXS Conversion	Birdhunter50	02/04/16 11:39 AM

Extra information

0 registered and 35 anonymous users are browsing this forum.

Moderator: CptCurl

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 1346

Jump to

NitroExpress.com

Powered by UBB.threads™ 6.5.5

Home | Ezine | Forums | Links | Contact

Copyright 2003 to 2011 - all rights reserved