Forums.NitroExpress.com

Home | Ezine | Forums | Links | Contact NitroExpress.com: 10 gauge 31/2" wads

*** Enjoy NitroExpress.com? Participate and join in. ***

You are not logged in. [Login]

Main Index · Search · Active Topics
New user · Who's Online · FAQ · Calendar

Shooting & Reloading - Mausers, Big Bores and others >> Shotguns

TomN
.300 member

Reged: 07/03/10
Posts: 149
Loc: washington

Re: 10 gauge 31/2" wads
05/01/13 11:55 AM

Daryl
I cut the bottom off the shot cup and used it for the gas seal and I took the top of the shot cup and cut the fingers back it just hold the .748 ball. As neather end has a good cup for holding the ball I cut it just short of the mid line of the ball and it seams to hold it centered. I then used 3 1/2" inch felt wads and one 1/4" over shot wad to get the ball to the right hight and was a lot more careful with the pressure that I used to close the crimp. These are put up in Fed. 31/2" shells that had a 15/8 oz load of shot so at under 700 grains they should be ok as I have sean peolpe replace one oz. of shot with a one oz. slug with out harm. I loaded 3 like this and will shoot them and check them over to make sure that they look ok and that they fall out of the gun easely. If they work ok I will load 6 six and see what kind of group I get if they work well I will load the rest of the box and shoot them.
Tom N

Post Extras

Entire topic
Subject	Posted by	Posted on
10 gauge 31/2" wads	TomN	22/12/12 12:32 PM
Re: 10 gauge 31/2" wads	DarylS	22/12/12 12:44 PM
Re: 10 gauge 31/2" wads	TomN	22/12/12 01:10 PM
Re: 10 gauge 31/2" wads	lancaster	23/12/12 12:46 AM
Re: 10 gauge 31/2" wads	Kiwi_bloke	31/12/12 01:49 PM
Re: 10 gauge 31/2" wads	TomN	01/01/13 06:09 PM
Re: 10 gauge 31/2" wads	DarylS	02/01/13 06:02 AM
Re: 10 gauge 31/2" wads	TomN	02/01/13 06:46 AM
Re: 10 gauge 31/2" wads	TomN	03/01/13 12:27 PM
Re: 10 gauge 31/2" wads	DarylS	04/01/13 02:51 AM
Re: 10 gauge 31/2" wads	TomN	04/01/13 04:36 AM
Re: 10 gauge 31/2" wads	DarylS	04/01/13 05:11 AM
Re: 10 gauge 31/2" wads	TomN	04/01/13 09:55 AM
Re: 10 gauge 31/2" wads	DarylS	04/01/13 10:28 AM
Re: 10 gauge 31/2" wads	TomN	05/01/13 11:55 AM
Re: 10 gauge 31/2" wads	DarylS	06/01/13 04:53 AM

Extra information

1 registered and 13 anonymous users are browsing this forum.

Moderator: NitroX

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 4494

Jump to

NitroExpress.com

Home | Ezine | Forums | Links | Contact