Forums.NitroExpress.com

Home | Ezine | Forums | Links | Contact NitroExpress.com: Initial barrel convergence setup

*** Enjoy NitroExpress.com? Participate and join in. ***

You are not logged in. [Login]

Main Index · Search · Active Topics
New user · Who's Online · FAQ · Calendar

Double Rifles, Single Shots & Combinations >> Building Double Rifles & Gunsmithing

450_366
.400 member

Reged: 17/01/07
Posts: 1068
Loc: Sweden, west-coast.

Re: Initial barrel convergence setup
01/04/10 04:51 PM

The problem as i see it is that the more you need to bend the barrels (out if an old set of shot tubes are cut, and in if a new is built with parallell holes) the worse will it behave when getting warm. If you could set them at the right angle from the start to regulate it would be awsome, but that newer happens but as close as possible is what i would try to do.

--------------------
Andreas

"Yeas it kicks like a mule he said, but always remember that its much worse standing on the other end"

Post Extras

Entire topic
Subject	Posted by	Posted on
Initial barrel convergence setup	sullyva	09/02/10 11:13 AM
Re: Initial barrel convergence setup	akjeff	09/02/10 01:01 PM
Re: Initial barrel convergence setup	baileybradshaw	09/02/10 02:30 PM
Re: Initial barrel convergence setup	CHAPUISARMES	10/02/10 11:24 AM
Re: Initial barrel convergence setup	Ron_Vella	01/04/10 12:11 PM
Re: Initial barrel convergence setup	450_366	01/04/10 04:51 PM
Re: Initial barrel convergence setup	Paul	01/04/10 11:38 PM
Re: Initial barrel convergence setup	VonGruff	02/04/10 06:43 AM
Re: Initial barrel convergence setup	450_366	02/04/10 07:26 AM

Extra information

0 registered and 15 anonymous users are browsing this forum.

Moderator: CptCurl

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 1260

Jump to

NitroExpress.com

Home | Ezine | Forums | Links | Contact