Quote:

---

Andreas-


Barrel-length is going to be one issue there, pump and auto will have short tubes, also the autos will have gas-vents drilled in them at some place.
Also, most everything out there is set up for sub-caliber sabot ammunition - with fast twist.

There are likely properly bored muzzle loader barrels with the right twist that could be contoured and sleeved in as full-length liners, or one could be bored and rifled by one of a handful of US barrel makers.




Cheers
Tinker

---

Yeas off course, the lenght would as usuall would be a problem
But i would shorten the original a bit anyway if it was mine, but if there are only rapid twisted to get i wouldnt matter.

Here around there are almost no production of barrels, there is one guy that makes them but i havent got the contcts for him so thats as good as nothing.

But any ml builder shoul be able to supply a blank.

--------------------
Andreas

"Yeas it kicks like a mule he said, but always remember that its much worse standing on the other end"

Post Extras