Forums.NitroExpress.com

Home | Ezine | Forums | Links | Contact NitroExpress.com: questions for Tinker

*** Enjoy NitroExpress.com? Participate and join in. ***

You are not logged in. [Login]

Main Index · Search · Active Topics
New user · Who's Online · FAQ · Calendar

Double Rifles, Single Shots & Combinations >> Building Double Rifles & Gunsmithing

Birdhunter50
.375 member

Reged: 03/06/07
Posts: 815
Loc: Iowa,U.S.A.

Re: questions for Tinker
10/07/08 08:24 PM

Dale,
Tinker is right in his advice about welding the tubes to the monoblock, this is not the place to weld. Welding on the barrels can cause scaling inside the barrels and cause the monoblock to become brittle. There would be no right way to re- heat treat the barrels/mono. after welding. Proper solder jointing will be more than strong enough. If you want an almost invisable joint you can try what Mr. Ellis Brown suggested in his second edition and leave the barrel shoulders just a little high and peen them after soldering so as to close the gap, or you can do what I do and lap the joints together before soldering. That will make the joint almost invisable. If you want the details, send me a PM. Bob H.

Post Extras

Entire topic
Subject	Posted by	Posted on
questions for Tinker	dale	10/07/08 03:27 PM
Re: questions for Tinker	Birdhunter50	10/07/08 08:24 PM
Re: questions for Tinker	DarylS	10/07/08 09:39 PM
Re: questions for Tinker	tinker	11/07/08 05:15 AM
Re: questions for Tinker	dale	11/07/08 06:06 PM
Re: questions for Tinker	tinker	11/07/08 06:50 PM
Re: questions for Tinker	tinker	10/07/08 04:53 PM
Re: questions for Tinker	dale	10/07/08 05:38 PM
Re: questions for Tinker	tinker	10/07/08 06:37 PM

Extra information

0 registered and 82 anonymous users are browsing this forum.

Moderator: CptCurl

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 668

Jump to

NitroExpress.com

Home | Ezine | Forums | Links | Contact