Quote:

---

450-366

Just for starters, bushes to fill in the excess between the existing rim cut and the new, making extractors/ejectors. Sight blocks. and many other things.
Some are better done on a mill, but if one hasen't access to a lathe, then one must presume a mill is also unavailible.
I supose that it could be done with very carefull planning and pre-measurment, however it leaves no margin for adjustments.
A good lathe should really be the pre-requisit of even a well equiped amateur machine shop.

Regards

---

Offcourse its better to have a lathe and no garage is complete whitout one. But its not impossible to do it without, it only take much longer. There are plenty of companys that could provide their service on the small parts.
What i mean is that the absence of heavy machinery shouldnt stop anyone from trying. In worst case you would be left with the fact that you need paying someone else to do some steps. There are shops building complete semiauto guns with only a pair of files so if you got the time everything is possible.

--------------------
Andreas

"Yeas it kicks like a mule he said, but always remember that its much worse standing on the other end"

Post Extras