Quote:

---

I am hoping I can find a mount that doesn't require leaving anything behind when the scope is removed. If something can be milled into, onto, or along the sight rib then I can clean and oil it completely when the scope is removed. Ruger No. 1 mounts work like that but Ruger's rings aren't the best and I don't know if milling out the rib for Ruger rings is practicable.

---

Take a look at the photos in this article http://www.martiniandhagngunmakers.com/technicalinfo.htm It shows Talley detachable scope rings mounted into slots milled into the 1/4 rib. However, I can't tell if the rib is integral (i.e. the barrel blank was milled to leave the rib), but I suspect so. Its the neatest I have seen ...
Best

Edited by JabaliHunter (26/03/08 05:30 AM)

Post Extras