mckinney
.400 member
Reged: 29/01/09
Posts: 1237
Loc: usa
|
|
Here is an early Type B or possibly Type C in 6.5mm. Serial number is 2951 and the receiver ring is marked "Waffenfabrik Mauser Oberndorf A/N 1901". The left receiver wall is not marked in any way and there are no caliber markings on the exterior of the gun. Under the barrel it is marked only "6,5". I haven't done a chamber cast, so I don't know which 6.5 mm cartridge it is chambered for. The bolt has the long narrow gas ports like a Kurz action, but I don't know if it is a Kurz action. The sight ramp is marked 1 through 10 rather than 100 through 1000. The buttplate is marked with the early logo, but in a smaller version than I have ever seen. There is no cheekpiece, suggesting it might be a Type C, but I have seen no mention of Type C's in 6.5 mm.
Anyone have any idea what this rifle might be?





Edited by CptCurl (26/12/11 11:47 PM)
|
Igorrock
.400 member
Reged: 01/03/07
Posts: 1684
Loc: Finland
|
|
If your Mauser is "Kurz", it could be 6,5x54 Mauser too. It seems that it`s small ring and allmost all those short actions are such. The overall length of the actions should be about 8.125".
-------------------- http://promaakari.wordpress.com/
|
justcurious
.333 member
Reged: 17/03/10
Posts: 285
Loc: Germany
|
|
Transitional action in typical configuration (Standard length action,stock with side panels) what later would be named a Type B.
Tangent side with windgauge is a nice ad .
Typical for Type C was the stepped barrel.
The Caliber might be the 6,5 Portugese .
A very rare item . Congrats
|
Igorrock
.400 member
Reged: 01/03/07
Posts: 1684
Loc: Finland
|
|
I can´t see any real side panels in mckinneys stock, just a normal back curve which is typical for some Mauser sporster stock models.
-------------------- http://promaakari.wordpress.com/
|
justcurious
.333 member
Reged: 17/03/10
Posts: 285
Loc: Germany
|
|
Quote:
I can´t see any real side panels in mckinneys stock, just a normal back curve which is typical for some Mauser sporster stock models.
Name it as you like. Perhaps one could say a partial side panel.
That type of back curve is normal exclusively on Pre WW 1 Commercial Mauser rifles.
|