|
|
|||||||
Anyone with surplus to requirements?? Thank you in advance Eric |
||||||||
|
|
|||||||
I had a very nice Mauser TypeA in 6.5 Portuguese and, although I never shot the rifle, I was able to take 7x57 brass and use my 6.5 Dutch dies to neck and set the shoulder to chamber with reasonable bolt closure resistance so I think that fire forming would be quite feasible. Brass may end up a tiny bit short but should work just fine. |
||||||||
|
|
|||||||
got my 6,5x57 die set in an internet auction for 25 euro if you get such a die set cheap - I would cut it mm for mm until the case fits into the chamber. must be fine for bullet seting out of the box. 6,5x58 6,5x57 |
||||||||
|
|
|||||||
Apologies to all, for the lack of response. Thank you for the helpful advice. Best Eric |