Lancaster. I finally got around to dismantling the Dryse this morning and to my surprise it looked like new inside. It was packed full of some sort of grease that looked like the old style of bearing grease and had set up hard. Took about three hours to clean it all out. I was looking at your previous post about reloading and it left me with a few questions. When you turn the percussion cap up side down and insert it in the primer pocket doesn't it cover the flash hole and block the burn to the powder charge. and my second question is, what is the cartridge over all length 70mm?. What are you using for a powder charge. These shells are a little smaller than a standard 20ga so are you using the 20ga over powder and cushion wad. Enquirering minds want to know. Thanks