THE FENIX P3D
FLASHLIGHT

I have purchased yet another light of the Fenix line. The new torch is the Fenix P3D, a multi-level light running on two 123 batteries.
The P3D I bought uses a premium (Q5) Cree 7090 XR-E LED. The light is digitally regulated and has six levels of illumination.

There are two modes of output that are selected by turning the bezel. The general mode is: 12 lumens for 65 hours, by softly pressing the switch; the second mode will be 53 lumens for 13 hours; pressing again will put you in the 120 lumen mode for 4.8 hours; and again will access the SOS mode (also 120 lumens).

By turning the bezel you can access the turbo mode at 205 lumens, and pressing again softly on the switch will put you in the strobe mode of 205 lumens.

The light has a low battery indicator. The indicator will strobe the light in low, very fast light; I had opportunity to test this when I put two inexpensive 123 batteries that I thought were both fully charged.
It seems that one of them was with a very low charge, even though it was a new purchase. I had learned to use only the best 123 batteries that I believe are the Surefire brand.
Putting the Surefire batteries in the P3D allowed the light to operate without a hitch.

The light is 4.5” long and 0.8 in diameter. The anodizing is type III finish and the lens has an anti-reflective coating similar to what is put in eyeglasses.

As like the other models of Fenix lights, the P3D also can be used in candle mode, as the rubber button doesn’t protrude like in other lights that are uses as tactical.

A word of advice; use the 205 lumen mode very sparingly. The light gets hot very quickly in this mode and the excessive heat can damage the Cree emitter if used for a long time. If you need a light that can be used without damaging the LED in the higher setting for a long run, you have to purchase the Fenix T-1 that has a massive heat sink and bulky head that will draw the heat away from the Cree.

As the LED’s lack the infrared spectrum of light, the heat is concentrated near the head, instead of been thrown forward as the incandescent lights do.
The light comes with a handy holster. This is one torch that I don’t mind not having a clip, as the holster is very flat and comfortable to wear.

This light is so handy that it has replaced my Surefire E2e that was the light I used to wear for years when I went out of the house. I also have another light on my key chain, another Fenix product, the L1D, a one AA battery light with multiple levels.

Carrying now the two Fenixes, I will have light for a long time if I am involved in a situation that I need to use them.

The P3D can be used as a tactical light if the distance involved is short, like in an interior house situation. However, if the light were to be used to illuminate somebody in the back yard, the brightness of the 205 lumens at say, my usual distance of 26 yards, will be not be sufficient to blind a person as the tactical lights are supposed to do. I know because I tested it on myself at that distance, and the blinding effect was not present.

To illustrate the point I use another light that is also in the 220 lumens bracket, the Bear Cub incandescent, 220 lumens for 90 minutes. If you look at the pictures you will notice how strong the concentrated white beam of the Bear Cub is in comparison to the flood light of the P3D.

Also notice to the right of the subject how the incandescent light reveals leaves that are not shown in the beam of the Fenix. This is the famous lack of definition that I often talk in my posts; it can be translated as lack of detail from the LED beam.

For that reason I think that the 26 yards to the fence is the maximum range of the little reflector of the P3D. Bigger reflectors like in the Fenix T-1 with the same Cree Q,5 can reach as far as 50 yards. A word of advice, don’t try to make the little, svelte P3D do the job that is designed for the T-1, just confine the P3D for the house and other places with short range.

P3D beam from 26 yards,

Bear Cub beam from 26 yards

Coming back to the P3D, it has a strobe effect in the 205 lumens setting; it will not do anything different to my eyes than the actual steady 205 lumens light can do. Must be all my disco dancing in the ’70 had me accustomed to the strobe effect.

The little torch is good, that is why it is my new light over the E2e. Placed in the holster or in your pants pocket, you hardly know that the light is there and a lot of cool features and power are just at your fingertips.
I recommend it highly.
Regards
Watchmaker