That was over three years ago! I guess I owe an update.

First, here's a look at the mould Mike made for me:

You have already seen the bullets I cast from it (above).

Now, have a look at a fantastic set of custom dies:

The shellholder was store-bought from Buffalo Arms.

The tools consist of a push-through ring bullet sizer (left); a sizing die (center); and a crimp die (right). The tools are 1-1/2" diameter and thread into an RCBS AmmoMaster press.

Below you see two empty cases on left and two loaded cartridges on right.

Here's enough to dislocate your shoulder several times over:

Anybody want to come shoot with me?

Curl