Lee Precision might be talked into making a sizer body that fits standard presses (or the oversized, 1" hole in some presses) for any size you want. In smaller sizes at 7/8x14 thread, they charge something like $30.00 per die now.
You have to phone their custom shop as this service is not listed on their web site.

With their sizer dies, comes the close fitting plunger that fits the ram like a shell holder.

Lube the bullet and push them through - VERY simple. They come out the top, one after the other. Push a bullet into the die and take one off the top.

These dies, in successive sizing of about .003" can be used for drawing bullets to smaller sizes, ie: .338's to .330" and .375's to .366" for instance. A buddy uses a set of 3 dies from Lee for drawing 225gr. .323's to .312" for his .303 Brit. - with excellent results.