I will start a new thread as I have started to shoot balls from this gun. I loaded 4 .748 balls in shells that I took the shot and shot cup out of and replaced it with the ball and a shot cup that I had cut the bottom and the fingers off I used fiber wads and one over powder card and a 6 segment crimp to keep it all in. they shop ok I had 3 holes in the board in a 8" group not very good but would have killed any deer that was hit. I also loaded one new shell with a load of 34.5 grains of SR7625 and the shot cup with the seal cut from the bottom and the fingers cut back to just keep the ball centered with 3 felt wads and one over powder card the other shell I loaded was the same load of SR7625 with the shot cup cup as befor but with 4 felt wads and a 8 segment crip. These last two were on the same plane and about 11/2" apart just to the right of the spot I was shooting at. I will have to load a few more of them to see how they are really shooting but if I can repeat the shot plasment I would be happy with it. All the shells droped from the gun so I fell that the load is not to much I doin't have a way to see the F.P.S. but they felt a little stronger then the shots that I took with the shells that I made from just replacing the shot load. 34.5 grains is a load I got from the card that came with the lee hand tools I got to load the 10 gauge and its for a load of 2oz shot. well I will have to load some more of that load to see if it really will be as good as I hope will post new loads as I get them shot and checked.
Tom N