Hey guys,

After looking into molds, I decided that I am too poor at the moment to afford one, so I made my own. It worked out pretty good for a first time effort. Figured I would post it up here, just in case someone else is as poor and desperate as myself and wants to shoot round balls. All you need is an old aluminum heat sink block, a couple drill bits, a file, and a micrometer.

Anyway, start with this:

Then take your measurements, and bore out some holes:

Use a c-clamp to hold everything together, and start pouring:

End result:

Here is the "round" bit, and a normal spade bit for comparison:

Anyway, there it is. I know I was a bit brief, but I'm sure most everyone can figure this one out. Cheers.