Well my gun arrived a day earlier than expected. Pedersoli did as expected. The fit is a little sloppy around the tang but all else seems right as rain. As usual I got in a bit of a hurry an ordered some stuff a little early. Looks like I am going to have to make a sizing die for the cylindrical bullet. It drops from the mold at .452 and it needs to be .449. I did a little to much internet reading When I should have waited on the gun. The other Mold should be here in a couple of days. Its hexagonal and made for the gun by Pedersoli. I completed my Hex wad punch today and it punches out nice little hexagonal wads. At least something worked. One other thing of note the gun is so straight stocked that it is hard to line the sights up when the rear sight is set on the 100yd mark. Brit's must be built funny. No offense meant.