mauserand9mm, looks good!
Did you try & fit the bases tight to the receiver first before tightening the rings, otherwise they will rock about?
I've got QD Talleys, yep they take a bit of setting up too, but really are worth it!
The only problem I have with the Talleys is the holding bolt for the QD levers are too short & by the time you open them enough to release the scope off the receiver they fall apart dumping springs, levers etc everywhere - not happy Talley!
Apart from that they go back to virtually same point of impact!
All the best lining up on a pig - got the right tool for the job!
93x64mm