Hi!
I have not written a lot on your forums, but I've done quite a bit of reading.:p

So here's what I want to know: (I might not be in the right section, but hopefully someone will help me out

)
I have a Brno 21H with a pitted barrel (8x57IS) and a lousy stock.
I've been thinking about buliding a 10,75x68 on this action, perhaps in combination with a barrel in 6,5x55 for practice and smaller game.
Will this conversion take a lot of machining, for instance in order to get it to feed properly?
I don't think so, but i'm not sure as i'm a novise at these things

(No, I'm not doing it my self, and i haven't talked to my smith about it yet.)

I am also going to get a new stock for the rifle.

All replies are good ones