Hi Folks

I have recently had the opportunity to shoot my rifle on the range . At 100 yards , benched , it shot about 3 inches to the left with a 3 inch group at 9 o'clock position . The cheek weld is hard to do due to the height of the eye cup . Since it is a take down , I might have not tightened the barrel enough accounting for the 3 inch left on the indexing mark .

The only markings on the scope are on the mounting rail above with Bland's address and on the top of the elevation dial . 100/300 , 200 , 300 , etc out to 1000 and "for 375/303 Axite" .

Again , thank you all for the reply(s), you are all an amazing source of information . Jim