two years later

was trying to get a proper feeding from the original enbloc clip with 7,62x39 but at least with this action here it was a wrong way. the reason is the 7,62 cartridge is not guided between the clip and chamber.

now I cut the follower housing in two parts and steel pieces were welded and milled so they will made runners for a box magazine

bought a CZ 527 magazine for 7,62x39

the clip latch got an arm , fixed again by welding to hold the magazine in place. for this job a 2mm thick piece of steel will be soft soldered on the back of the magazine where in a groove than the clip latch can snap in.

we will see...