| 400NitroExpress |
| (.400 member) |
| 01/09/07 05:42 AM |
Re: 375H&H Magnum to the new 400H&H
|
Quote:
Hell, maybe I should just rebore the sucker to 450/400 3" if wall thickness is nominal..
I had the same thought and briefly looked at the .375 and .450/.400 drawings. The .400 is only 2.1" to the shoulder, with a .440" neck. The .375 is 2.4" to a .450" shoulder, so I'm not sure that the .450/.400 3" reamer would entirely clean up the .375 chamber. I haven't looked at it very hard though.
Maybe .500/.416?
Are the .375 bores shot out?