Hi Guys
It is so simple to make a bullet puller for both 470 and 500 cases .
Take one popular green kinetic bullet puller hammer.If the case dosen't fit run a drill down till it does,it won't be much material that has to be taken out.If you have acess to a lathe turn up a washer that will take the 470/500 case body and turn down the outside diameter so it will fit inside the plastic nut when it is tightened.then turn up another washer a bit thicker so that it fits up inside the top of the nut,bore a hole larger than the primer and the job is done ,when you are ready to dismantel you rounds place a foam ear plug in the bottom of the hammer so you don't damage the projectile
MERRY CHRISTMAS
sbs470