500N-

Thanks.
Note that my comment on bullet diameter was specific to the pair of cupric jacketed RNSN bullets pictured there. I haven't fiddled with Hornady solids, at this point I don't use solids in any rifle I own.



jep21-

Just exactly what is the issue with the chambers where they won't take a round of ammunition?
It was noted earlier that a standard chamber reamer had been run though them.
Are they fractured and sprung with a mangled tang of material hanging around in the space where a round of ammo should go?


--Tinker

In reply to:

---

FYI, the Woodleigh Steel jaket solids are fraction undersize. From the testing
I have done I still load 1 or 2 grains nder for Solids over what I load for the SN's

Also, the taper on a Woodleigh Bullet that is designed for DR's starts WELL before the cannelure,
not at the Cannelure as you say the Hornady does (ie 470 etc).

---