Roy,

The 4895 loads were not impressive. Velocity was below 2,000fps and varied significantly between the right and left barrels. I've done a deep cleaning with what I had at home, but am still was getting dirty patches after a lot of elbow grease and Hoppes No9, so I've ordered a non-ammonia copper remover and will try that.

I'll probably shoot the new loads before I cast both bores to see if the right barrel, which had lower velocity on each pair, is more worn than the left, or if the velocity was due to greater fouling.

My next loads will use 4198 and the 200gr Hornady JSPs. Based on loaddata.com I will start at 32.5grns. Those are ready and waiting a free window of time to get to the range (and weather that doesn't suck.)

Chris