Home plating kits are available here, electroless nickle, were the parts to be plated are just submerged with out needing to be attached to an anode. Thought I would get a kit and try on an old set of shotgun barrels. As I stated earlier - hard to find the right people to talk too. I think the local guy would just be doing parts for car restorers etc and the mere mention of "guns" is off putting. I know very little about the process. When masking with wax, It obviously it has a melting point above 90degrees. What is the best method of masking, melt the wax, dip the barrels in and then remove the wax from the area to be plated?

Regards,