| DeweyVicknair |
| (.275 member) |
| 16/11/16 01:23 AM |
Re: In the beginning...
|
Quote:
Could you set it up horizontal in the dividing head/rotary table using a stub through the hinge pin hole, supported by a tailstock ???
Being that it should (?) be on a radius with the hinge pin centre.
I don't understand your question, the action knuckle is done. It is most assuredly round and concentric with the hinge pin and no complex machine setup was required, indeed no machine was used.
The only tools used were 00, 2, 4 and 6 cut, flat files.