I am getting down to last of the milling on the receiver. Here are the to-do items:

I have to cut angle cuts in the watertable to accept the barrel lugs. The cuts require tw setups, one from the top and one from the bottom. They are a little hard to see but if you look at the original I think you can see the angle cuts.

The floor plate requires some milling to shape as you can see below.

The front of the water table must have the holes milled out. See below:

Finally, the upper tang must be milled to fit into the receiver.

I think with the above completed the receiver will be ready to polish, harden, and try the internals. It is about time.----Bill