I can add some new photos. They are just not as far along as I wanted them to be but they are illustrative of problems you may encounter.

This picture show indexing the mill to begin.

This is the mill progressing.

Mill at back end of travel.

[IMG]IMG]

You perhaps can note from this photo an example of a programming problem. If you look carefully at the top receiver you will see an extra groove that should not be there at the top of the bottom radius. We had to go into the program and find this anomoly and fix it or it would have ruined the receiver. It was only on one side and the other was fine. I was not milling the flats with this mill since we would use a different bit for that. We were only dealing with the radius at the bottom of the receiver.

Here is another shot.

I will try and post some video tomorrow if I can find out how. All for now.----Bill