Hello all,

I took my Daniel Fraser stock to the Doctor.

And ... my friend Dr. Mike did his magic with his x-ray machine and look what we found. A through bolt. And not anywhere near centered. I haven't done all the math yet, but it looks as though the access hole in the stock is going to intersect the lower butt plate screw plug in the rubber recoil pad. I couldn't have picked a worse place for it to be.

My question now is, does the tang screw go through a hole in the draw bolt, or is it a slot so the draw bolt can be tightened in 1/2 turn increments?

The small pins in this close-up x-ray below are spaced at 1" apart to get measurements for a detailed drawing.