MaxGera
(.275 member)
16/05/12 10:16 AM
Re: Shotgun Conversion Load Pressure

Hoosier,

If you look at one of my earlier posts, I show my set-up for machining that surface. The method that I use produces a very accurate "circle" in the receiver and it makes obtaining a good fit rather easy.

Here is a picture showing how the surface is machined by pivoting the receiver by hand against a very sharp and smooth broach. It leaves a mirror finish surface concentric to the hinge pin within less than .001 TIR.

It's a rather difficult surface to photograph clearly, but I'll try to get a good picture in the next day or so.



Contact Us NitroExpress.com

Powered by UBB.threads™ 6.5.5


Home | Ezine | Forums | Links | Contact


Copyright 2003 to 2011 - all rights reserved