Hello all,
I am new to this forum so this has likely been covered before and if so just direct me to the proper place. I am building a DR in 45-70 on a 20 ga Winchester 21 receiver and monobloc. I have the barrels in the monobloc,front lug attached and front spacer in place. I need to cut the ejectors, add the ribs, chamber, and regulate the barrels. Herein lies my question and request for input. I need to specify a load, i.e. powder and bullet to regulate my new barrels. I will be using it potentially for deer, moose, elk, and boar. I plan on carefully reloading a hundred or so for the regulating process (hope it doesn't take that many). I would appreciate any advice and experience you have. My project is a winter project so I have time consider all your inputs. Thank you.---Bill