I got blind hog lucky - barrels lined up just about perfectly with firing pins, right barrel angled a hair more in than down, left the other way, more down than in, just a hair --

no sighting system yet.. perhaps tonight, if it lives doing the high prrof off road boogie ...
(proof loads whilest tied into a tire, at the end of a LONG rope)

here goes nothing..
fore and aft soldered in..
check

chambered and headspaced to nil
check
check

leave barrels FULL - not cutting extractor groove till after proofing
check
check

load half a dozen proof loads (i REALLY would prefer it to blow in the rack, not in my hands)
check...x6

load a couple nominal loads to see how its going to work
check x a bunch

Loaded up and headed to Rodney's --
If this is my last post, it's been a great ride

jeffe