Anyone used this stuff? I've typically used accraglass for any sort of stock work but used Gorrilla Glue in building some gun cases last year. The stuff worked amazingly well. I just spent the morning cutting a fore end for a light Belg. made 20 bore. It has one of those push button latches. Problem is the knuckle has projections fitted into the wood and a curve away from the wood. Not so difficult except that the foreward end where the button is also has a bit that fits over the front of the wood! Ruined two pieces trying to get both ends tight... Finally settled for a thin gap at the front and after final fitting glued on a sliver cut from the same blank during the rough shaping processes. I know the GG leaves invisable joint lines so I gave it a try. I'll let you know how it turns out!