G'Day Fella's,

I was recently reading an article/thread that originated from the "Cast Boolits" forum.
It appears they have spilled the beans on how the Australian Hard Cast bullet industry, have been coating their bullets!
They have been using a combination of the dry powdery product, that they use to "Powder Coat" items with, dissolved in Acetone! They apply this liquid to the "As Cast" bullets with a spray painting gun, and then bake it in an oven (375 to 400*F), to cure and set it prior to sizing the bullets!

They are achieving some impressive velocities (2000 + fps), without any sign of leading!!!
I will locate this again and attempt to post it here!

Hope that helps

Doh!
Homer