Folks, I have acquired a .404 CZ550 recently & would like to do some casting to ease costs a little. In the shop at present getting the trigger redone & bedded - none what so ever on Safari classics here in Oz. We seem to be the poor cousins over here, & I'm not the only one to have this issue!
Firstly where can i get here in Oz a Lyman/RCBS type sizing die for a .423" projectile?
Do I get a .417" one & rebore to suit say .001" oversize with a new inner or use a Lee type push through type - if we can get them sent out?
Also single cavity moulds, can we get these here in .423" from CBE in 400gn+ - any ideas on cost if they can?
Finally if using a gascheck type projectile would Lymans No2 or "hardball" be OK to use if pushed to 2150fps+
Still waiting on dies & cases.....luckily not holding my breath!
ANy help would be appreciated
93x64mm