Daryl
Yes it's a 10 bore I have tryed the .715's and I got some .748's but when I put them in the cut back shot cup they tend to bulage the shot cut and the shell so as not to load. What I am hearing you say is to cut the fingers off the shot cup and turn it over and use the cup at the bottom of the shot cup and keep the flat part on the fiber wads or should I just cut the cup off the shot cup and put it right on the fiber wads? The 690 would fit insied the shot cup with the fingers cut off to just mid ball and seam to hold it in the center the others I have seam to be to big to do that but if I should be turning it over I would use the .748 ball and hope the presser would keep it centerd as it looked to small to fill the cup and seams to let the ball roll arown inside of the cup on the bottom of the shot cup thanks.

Tom N