(.375 member)
10/01/07 10:57 AM
Re: 12GA From Hell

Here is pictures of the breech, lever,
linkage, etc, set up on a block to
get the geometry for the scaleup model working
ok.And setup measurements to make the breech
hole in the action, in right place.Also used
this model to get hammer and trigger set
up to ride on the breech block. With
a strong hammer and trigger in the right
place in the guard.In the pics above you see the pin the
lever pivots on. The actions being bigger
will be wider than the levers;So the space on the
pivot will be taken up by the Ruger
style extractor on the left side and a spacer
on the right side. Spacer also acts as a
breech block stop at the bottom of the
breech travel.So to get block stopped at
right position for the diameter of the case
and feed trough, we adjust spacer size.
Ruger extractors from GP changed
a little bit will do.Ed.

Contact Us

Powered by UBB.threads™ 6.5.5

Home | Ezine | Forums | Links | Contact

Copyright 2003 to 2011 - all rights reserved