60 grains of 4895 with a tuff of dacron filler is a wonderful cast bullet load. Quite powerful. I have a NEI mold that goes about 378 grains with lube and gas check. This is the bullet second from the left in the photo below. The bullet on the far left is a Mountain Mold 350 grain flatnose but it doesn't feed as well.
Another load that I use is 31 grains of trailboss which fills the case to the base of the bullet. This is a light pinking load that shoots to the same point of impact at 50 yards as the first load. [image]

[/image]