Forums.NitroExpress.com

Well fellows this information is too good to keep to myself so here we go.

I had read an article in another gun publication regarding a new copper remover that really worked without the scrubbing and general pain in the ass steps necessary to get the copper out of your bores.

I immediately ordered three bottles which arrived today. Actually the product is packaged in small, pressurized 3 ounce cans. Attached to each can is a small, black nipple that is supplied for 22 caliber bores and a piece of clear, plastic tubing that slips over the nozzle for larger bore rifles and handguns.

I shook the can for a couple of minutes as there is a small ball bearing in the can to stir up the mixture. I attached the clear tubing and grabbed my 465 barrels. I inserted the tubing inside the right barrel, held my finger over the muzzle and pressed the button on the can. Within a moment the foam started creeping out of the right chamber. I pulled the tube out and placed it inside the left barrel chamber and pressed the button again. The foam filled the barrel quickly and I removed the tube and stuck a pair of rubber stoppers in the chambers. I then leaned the barrels against a chair and let the foam work for 45 minutes. I grabbed a cleaning rod with a jag attached and pushed it through the right barrel. I changed patches and did the same thing to the right barrel. A little of the foam was on the outside of the muzzles and I wiped it off and held the barrels up to the light. I was amazed to see that the bores sparkled as never before! I looked carefully at the bores from the muzzle end and every bit of copper that was there prior to using the foam, had completely been removed! Please bear in mind that this rifle had quite a bit of copper residue built up near the muzzles. Again, it was gone!!

You should also know that this foam contains no ammonia, has no odor, and wipes off with a paper towel. You can use this product in the house without stinking up the room with chemical smells! I am really impressed and I am sure you will be as well! Following is the address and phone number of where you can get some for yourselves.

Copper Removal Foam

From: Clean Gun, LLC
PO Box 211662
Bedford, Texas 75050

877-269-8490 phone

The price is $ 9.99 per can plus shipping.( I bought 3 cans and the total shipping was 6.50)

If a bore is heavily fouled you can fill it with foam and leave it overnight.

I will be curious to see what kind of results you all get from this product.

Post Extras